300-N/55 300 Series Tool Kit

300-N/55  300 Series Tool Kit

Dremel shaft lock spinning

I have a Dremel 300 and the shaft lock assembly isn't working to hold the shaft so I can get the collet nut loose. When I try to get the collet nut loose while holding the button of the shaft lock the shaft lock just spins along with the collet nutso I can't get the nut loose.

★ ★ ★ ★ ☆ 4.0 stars

300-N/55  300 Series Tool Kit

Product Troubleshooting for 300-N/55 300 Series Tool Kit


Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Answers :


Trying to fix a similar issue. The pin that gets pushed in by the button (and returned by the spring) seems to be fine. The hole in the rotating shaft that the pin fits into, however, is in the wrong place, so the pin never goes into the hole! All I need to do is somehow pull the whole front part of the shaft out about 1/16th of an inch, and it'd be fine. I just can't seem to budge it though. Any tricks, anyone?

Research, Knowledge and Information :


Shaft Lock Assembly [2610009839] for Dremel Power Tool ...


Buy a Dremel Shaft Lock Assembly ... Remove motor assembly to get to old shaft lock and remove it. ... Had to try about 8 or 9 times to get the motor to spin freely.
Read More At : www.ereplacementparts.com...

How to Replace the Lock Pin on a Dremel 395 Moto-Tool ...


This article will walk you through the steps needed to replace the lock pin and ... How to Replace the Lock Pin on a Dremel 395 ... stop the shaft from spinning.
Read More At : www.ereplacementparts.com...

Fix Your Dremel 225 Flex Shaft - Instructables.com


This is a simple yet really affective way to service/ Repair your Dremel 225 Flex Shaft Tool.I am sure there ... grip the shaft lock button and logo does ...
Read More At : www.instructables.com...

Dremel EZ402 EZ Lock Mandrel - amazon.com


Dremel EZ402 EZ Lock Mandrel ... I couldn't cut off the power before the thing just bent from spinning off ... but you will need these to run any "EZ Lock" Dremel ...


Fixing a Dremel® Hand Held Rotary Drill | Home, DIY & Stuff


Fixing a Dremel® Hand Held Rotary Drill. Our hand ... Removal of the brushes allowed easier removal of the motor stator shaft later in ... Position the lock pin and ...
Read More At : www.homediystuff.com...

Attachments - dremel.com


They are also spinning 30,000 to 35,000 ... press the silver shaft lock button on the hand piece of the ... you can use the #4486 Dremel Chuck with the Flex Shaft.
Read More At : www.dremel.com...

How to Fix Your Dremel Tool by Noah Vawter - YouTube


Dec 05, 2011 · One part of the common Dremel tool is actually very, very easy to repair yourself. This video shows you how! For more Do-It-Yourself stuff, especially ...

Hands-On: Dremel’s XPR 400 Series Kit | Toolmonger


Aug 30, 2007 · At the heart of the kit lies Dremel’s XPR 400 series ... tightens nicely by pushing the shaft lock button and ... but employs a spinning planer bit ...
Read More At : toolmonger.com...

Having problems with your 300-N/55 300 Series Tool Kit ?

Loading ...

Load time: 0.0133 seconds